Dotazy k Panasonic TH-42PZ700E

[MegaLampa]

Co se stane, když přivedu do TV signál 1080/24p z PS3? (samo, že po upgradu firmware)
Uděla z něho 1080/50p nebo ho nezpracuje vůbec??

Má smysl ještě dodávat převzorkovaný obrazový signal z DVD přehravači na 1080p, když TV má stejně
obvod na převzorkovaní standartního rozlišení DVD na 1080p??
(Měl by se o to postarat procesor V-real PRO II)

Jak to je s obrazovou frekvencí teto TV?
Půjde frekvenci zobrazování navolit na 100HZ ?
Jako např. u teto plazmy?

http://www.novinky.cz/internet/plazm...168_8943g.html

Zhruba po kolika minutách je obecně u plazem již nebezpečné nechávat statický obraz?
(Nemluvím tady o logach TV stanic - s tím už si snad poradí)

Stačí HDMI 1.2 pro barevný prostor YV12 Blu Ray disků nebo již potřebuje 1.3?

Nevíte náhodou někdo datum uvedení modelu TH-42PZ70E?
(Vše stejné jak u TH-42PZ700E až na to, že nemá tak dobre repra a jeden přední HDMI vstup)

[elviszije]

As expected, the Panasonic delivered superb detail, from the amazing sculptured CGI chrome and flames on skull-head Blaze's bike, to the texture of the cement on the gravestones. When we checked the set's resolution we found that it fully resolved every line of the 1080i test pattern from our Sencore HDTV signal generator, and handled 1080p/60 and signals as well (it could not display 1080p/24 from the Sencore, and the Samsung BD-P1200 would not allow us to select its 1080p/24 mode, so we assume the Panasonic cannot handle 1080p/24--not a big loss in our book anyway). It's worth noting, as always, that on a smaller screen the benefits of 1080p native resolution are less obvious than on a larger screen. For example, to be able to discern between the vanishingly thin one-pixel-wide lines of the Sencore's pattern, we had to sit about four feet from the screen. Any further back and they blended together, losing the benefits of 1080p.
http://reviews.cnet.com/flat-panel-a...Search+Results

Verzia s U nakonci, je totozna s nasou TH-42PZ700E, rozdiel je v napajani..

[elviszije]

Set whether to use 1080p 24 Hz video output mode for output of Blu-ray Disc (BD) video.

Automatic: Automatically switch the video output mode to match the TV that is connected.

Off: Output BD video at the maximum resolution that has been selected in the video output settings of the PS3™ system. (The video output will not be displayed at 1080p 24 Hz.)

Notes
This setting can be used only when [HDMI] has been selected in [Video Output Settings] under (Settings) >
(Display Settings).
The TV or AV amplifier (receiver) that is being used must support 1080p 24 Hz video mode. For details, refer to the instructions for the device in use.
The BD in use must also support 1080p 24 Hz video mode. Generally, video is recorded in 1080p 24 Hz resolution for commercially available BD video software (BD-ROM) on which "1080p" is displayed as the recording mode.
If video does not display correctly when [Automatic] is selected, set this option to [Off].

[MegaLampa]

Nejsem z toho moc chytrý.

Jak tomu rozumíš ???

[Atola]

Hm... kdybych chtěl v angl. jdu na forum někde na .com